Qnergy PowerGen 5650 Series, Installation & Operation Manual

Page: 75 / 194

I
NSTALLATION
P
ROCEDURE
63
7mm, 8mm open end wrench 1 Various tasks
1 1/8” open end wrench 1 Helium Fill (Staubli Cap)
6”, 12” Adjustable wrench 1 Various tasks
Pipe wrench 1 Gas fittings
Teflon Tape and/or pipe dope 1 Gas fittings
Torx Bit (Driver), T-40 1 Gas Valve Tuning
Screwdriver set 1 Various tasks
Small screwdriver set 1 Terminal block connections
Wire strippers, 28-8AWG 1 Wire connections
Crimpers 1 Wire connections
Flashlight 1 Various tasks
Lifting Equipment for PowerGen
Base and HRU
1 System Location
5000-103913-000, Helium Fill Kit 1 Helium Fill
6000-103634-000, Helium Gas
Cylinder (UN-1046)
1 Helium Fill (˜12 liters/engine)
Laptop, CAN bus cable connected
to FPC. Read Head 1 and/or 2
temperature readings
1 Helium Fill, measuring engine ambient
temperature
Laptop, pre-configured with
Qnergy Lynx Software, CAN bus
Driver
1 Commissioning PowerGen
4520-101097-000, CAN bus Cable
Kit
1 Communicate to FPC for Commissioning
PN: 3837, LM-2 Hand-held
Lambda sensor and display
(Innovate Motorsports)
1 Gas Valve Tuning
*Preston AF2000 Cor-Guard,
Concentrate, or 50/50 mix (4.2
gal total) or equivalent
1 gal Coolant Fill
Table 11-1 Tools and Materials
Description Quantity Purpose