Qnergy PowerGen 5650 Series, Installation & Operation Manual

Page: 66 / 194

Q
NERGY
L
YNX
S
OFTWARE
54
6.5 FPC & QEC FAULTS TAB
This tab displays the faults that are currently active on the PowerGen.
If System Status displays a Fault see “Troubleshooting” on page 111 to locate specific fault code
(ID) data.
Figure 6-51 FPC & QEC, Faults Tab
Figure 6-52 FPC & QEC, Fault Log
CHANGING FPC and QEC SETPOINTS AND PARAMETERS
• When changing a setpoint or a parameter within the Qnergy Lynx software the “Border” of
the parameter setting will change color and a “SET” or “UNDO” button will appear.
• When making a parameter change, an “ORANGE” border color will appear if your setpoint is
within an acceptable range. The orange border indicates that the change was not yet
applied.
Table 6-45 FPC & QEC, Faults
Control/Indication Description
Fault Log Fault Id – See Table 15-2 on page 113.
Description – Type of fault
Severity – Warning/Fault
Timestamp – When fault occurred (s)
Clear Faults Button Button used to clear Faults