Caution: This process uses a caustic paste. Avoid contact
with skin, eyes and mouth and keep it away from
children and animals.
If you get some paste on your
skin, wipe it off immediately and wash with water to
avoid an alkali burn. If eye or mouth contact occurs,
quickly wash the area with plenty of water and see a
doctor. Keep discarded materials away from children,
animals, clothing and furniture.
Note: If you accidentally pull two white tabs in a row,
you will get two processing tabs out at the same time.
Both pieces of film will be ruined, and unless you are
careful, you may lose a third picture. Do not open the
film door. Grip both tabs firmly, pull them both out
together, and discard both pieces of film. This may cause
the developer to be spread around the inside of the film
holder. Open the door and, without disturbing the film
pack, clean the film holder and developer rollers.
4
Diecut and laminate the photograph to create the badge
or badges. (See
Diecutting and laminating instructions
on page 7-29.)
Film processing time
Be sure to process the film for the correct time, indicated
by an audible signal and a flashing green LED on the film
recorder 60 seconds after you pull the processing tab.
Picture quality is affected by processing time.
This standard processing time applies at room
temperature only. At lower temperatures, processing
time should be increased. See the instruction sheet
packaged with the film for more information.
7-8
ID-4000 output devices
