Panasonic KX-TD1232E, Installation Manual

Page: 206 / 713

L
3 Features
3-104 Features
Conditions
• Toll Restriction check is done before LCR is applied.
• LCR works according to the selected dialling plan. If the user-dialled
number is not found in the dialling plans, the dialled number is sent out
with Local Access (Automatic line access) Code.
• This feature also applies to Call Forwarding – to CO Line.
• The same code with different digits may be assigned in program [7X01]
“LCR Leading Digit Entry for Plans 1 through 8” or in program [7X20]
“LCR Exceptional Code Set.” In this case, the code which has smaller
digits takes the more expensive route is priority. To prevent this, enter
“
” (wild card) after the code with the smaller digits. Examples are
shown below:
<Examples>
(1) The code priority is as follows:
“044” in program [7201] > “0444” in program [7101]
In this case, “044
” should be assigned in program [7201].
(2) The code priority is as follows:
“0332” in program [7120] > “03323” in program [7120]
In this case, “0332
” should be assigned in program [7120].
• When making a call to an ISDN line using the memory dialling, and the
number has a pause in it, the number after the pause will be sent to the
line as DTMF signals. This function is useful when accessing a special
network service which can be accessed only by the DTMF signaling.
Program [990], Area 07 – bit 1, is used to enable or disable this function
(default: disabled).
Programming References
Section 4, System Programming,
[100] Flexible Numbering, Automatic line access / LCR
[103] Automatic Access CO Line Group Assignment
[311] Emergency Dial Number Set
[677] PS Itemized Code Set
[7000] LCR Mode
[7002] BTL Access Code
[7003] Itemized Code Set
[7004] Internal ISDN Itemized Code Set
[7X01] LCR Leading Digit Entry
[7X11] LCR Time and Fee Set
[7X20] LCR Exceptional Code Set
[7X21] LCR Carrier Code
[7X22] LCR Carrier Modify Command
[7X23] LCR CO Line Group Assignment
[7X24] Authorization Code Set
[990] System Additional Information, Area 06 – Bit 5, Area 07 – Bit 1
Note:
X=carrier number 1-8