Panasonic KX-TD1232E, Installation Manual

Page: 417 / 713

4.6 CO Line Programming
Dial Mode Selection
402
System Programming 4-89
Description
Each CO line can be programmed for DTMF, pulse (rotary) or call
blocking. This program assigns your choice for each line.
DTMF: The dialling signals from an extension, either tone or pulse, are
converted to tone signals and transmitted to the CO line.
Pulse: The dialling signals from an extension, either tone or pulse, are
converted to pulse signals and transmitted to the CO line.
Call blocking: If your central office can receive both DTMF and pulse signals but
you are contracted for pulse, select this mode. When dialling on
the line with an MF4 telephone, only the pulse signals are sent to
the CO line.
Selection
• CO line number:
KX-TD816 – 01 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• DTMF / Pulse / C. Block (call blocking)
Default
All CO lines – DTMF
Programming
1. Enter 402.
Display : CO Dial Mode
2. Press NEXT.
Display : CO Line NO?–>
3. Enter a CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01:DTMF
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions
• In the case of KX-TD1232, CO01 through CO12 are for the Master
System and CO13 through CO24 are for the Slave, if available.