Omron Sysmac CP1H, Operation Manual

Page: 593 / 810

559
Installation and Initial Setup Section 9-8
3. For CPU Units with 30, 40 or 60 I/O points, switch DipSW4 of the CPU unit
to ON, if the Ethernet Option Board is mounted on the Option Board slot 1
(left side). Switch DipSW5 of the CPU unit to ON, if the Ethernet Option
Board is mounted on the Option Board slot 2 (right side).
For CPU Units with 14 or 20 I/O points, switch DipSW4 of the CPU unit to
ON.
Note DipSW4 and DipSW5 are OFF at shipment.
!Caution
In CP1H or CP1L system, option board setting should be set to Toolbus 115K
to ensure the work normally.
There are two methods to set this setting. One is to turn DipSW4 or DipSW5
to ON, and another is to set option board setting to Toolbus 115K by CX-Pro-
grammer.
Removing
Press the up/down lock-levers on both sides of the Ethernet Option Board at
the same time to unlock the Ethernet Option Board, and then pull it out.
ON
1
2
34
56
DipSW4
DipSW5
Press
Press
Lock lever
Lock lever