The DSP Toolchest
450
F.Rls
[0, 1k] ms
Sets the fast release of the sustain detector.
S.Rls
[0, 1k] ms
Sets the slow release of the sustain detector.
Master Bypass
{On, Off}
When enabled, fully bypasses the plugin.
UI Mode
{0, 1, 2}
Selects the UI of the plug-in: Basic, Basic with process metering, Advanced with process me-
tering.
Display Gain Range
{0, 1, 2, 3, 4, 5}
Sets the gain range for the process metering display.
Include Output Gain
{0, 1}
Sets whether the gain from the
Gain
control is figured into the process metering.
CV -> NCO Freq
• Synopsis: Convert Linear Control Signal to Control Signal for NCO
• Category: Building Blocks
• Channels: 1
Description:
CV -> NCO Freq converts a control signal in the range [0, 1] to a control signal for the
NCO - Numerically Controlled Oscillator
. You can specify the frequency that will be synthesized
when the input control signal is 0 using the
Lo Freq
parameter. Conversly, when the input control
signal is 1, the synthesized frequency is determined by the
High Freq
parameter. The frequency
genereated is linearly interpolated between these the frequencies specified by the paramters for
input signals between 0 and 1.If you set the
Lo Freq
to be higher than the
High Freq
, the
frequency synthesized will decrease as the input control signal increases.
Parameters:
Lo Freq
[1m, 22k] Hz
sets the frequency generated by a connected NCO when the input control signal is 0.
High Freq
[1m, 22k] Hz
sets the frequency generated by a connected NCO when the input control signal is 1.
Abs
• Synopsis: Generates the absolute value of its input
• Category: Math
• Channels: 1
