MIOConsole3d Session
331
Figure 12.19: Transport Header bar: Loop time display
When Loop playback mode is enabled, the current Loop range will be highlighted
yellow
on the Loop
timeline (as shown below left). The loop range will be shown gray otherwise (shown below right). (Please
also refer to this graphic as an illustration of In/Out and Selection modes.)
Figure 12.20: Transport Header bar: Timeline Loop, In/Out and Selection ruler and selection modes
Loop ‘Start’ reflects the start point of the currently selected loop.
Loop ‘End’ shows the end point of the selected loop.
Note that the Loop time display will also reflect loops defined by the selected Marker when in Loop play-
back mode.
The Time block
In/Out
section shows the Start, End and duration of the current Autopunch range.
Figure 12.21: Transport Header bar: Autopunch In/Out time display
An Autopunch range is created by dragging and adjusting a range in the
In/Out
timeline, as shown in the
timeline rulers graphic in the Loop section above.
When Autopunch record trigger mode is enabled, the Autopunch range will be highlighted
red
on the
In/
Out
timeline (as shown above left). The punch range will be shown gray in all other record trigger modes
(shown above right).
The Time block
Selection
fields show the Start, End and duration of the current timeline or segments
selection.
Figure 12.22: Transport Header bar: Selection time display
Timeline selections (shown above left) are displayed as a white range in the Selection timeline ruler. Time-
line selections may be created by selecting a range in the timeline ruler which will include all audio within
