ULN-8 Quick Start Guide
28
it is yellow, push the “Dim” button. If it is red push the “Mute” button. Now that you’re sure that you’re
looking at the Monitor Controller and that is not dimmed and unmuted, turn it down. The meters are now
showing the gain value of the Monitor Controller. This will happen any time you adjust an encoder.
Take a listen
With MHLink, you need to launch MIOConsole3d to establish the routing between MHLink and the Analog
Outputs on the box. The routing is established automatically as soon as you launch MIOConsole3d.
If you connect with USB, you don't need to launch MIOConsole3d to establish the output routing; it is
setup automatically by the box itself.
Note: The ULN-8 default configuration is set to receive audio from channels 1 and 2 from your computer,
and play audio out both the headphone jack and analog out channels 1 and 2 from the db25 and 1/4"
TRS jacks on the rear panel.
Using Legacy Interfaces
If you wish to compare your new 3d interface with an older “2d” Firewire MIO interface, you
can leave it connected as always and run them both at the same time.
All FireWire-based Metric Halo interfaces will operate as fully independent audio devices along-
side your Metric Halo 3d Ethernet-based interfaces.
