The MIOConsole3d Application
225
Category
Mic Pres
shows only analog inputs with internal mic preamps (ie. no LIO analog ins)
Digital
shows only physical digital ports (AES, ADAT, TOSLINK, SPDIF and MADI)
Host
shows the routable sources from your Host computer (either USB or MHLink)
SCP USB
shows the routable sources from non-Host USB ports
EdgeCard
lists only inputs from EdgeCards
SMPTE
lists only the dedicated SMPTE inputs on ULN8 and LIO8 units
Busses
shows the currently available Aux and Group buses in the current Mixer
Table 10.1. 3d Routing interface filter categories
Note:
“Cascade”, when checked, will create multiple input strips of the same configuration,
but with sequential input channel assignments (much like you have seen in other DAWs and
digital consoles).
For example, to create four stereo inputs from an ADAT input, hit [command-shift-A] (the key-
stroke for
Add Input Strip
shown in the Mixer menu).
In the routing window that pops up, click “Stereo” to create stereo input strips, select "Digital"
from the filter list on the left (to show only the digital inputs), select "ADAT 1” (as the first
channel you want to route from), type "4" in the Cascade box at the bottom of the routing
window (to create your 4 stereo strips), then hit ‘Apply’.
You will have created four stereo ADAT input strips, assigned from ADAT 1 & 2, ADAT 3 & 4,
ADAT 5 & 6 and ADAT 7 & 8, respectively.
This procedure is the same whether creating 2 strips or 72, mono, stereo or multichannel.
•
Add Aux Bus
is for adding a new Auxiliary mix bus to your mixer. If you have a strip selected in the
mixer and invoke
Add Aux Bus
, the new Aux will be added to the right next to your selected strip. If
no strip is selected, the new Aux will appear after the the last strip of your mix desk, all the way to
the right. The default key command for “Add Aux Bus” is
⇧⌥⌘A
(Shift + C A).
to customize your Aux bus behaviors.
•
Add Group Bus
is for adding a new Group bus. As above, if you have a strip selected in the mixer and
invoke
Add Group Bus
, the new Group will be added to the right next to your selected strip. If no
strip is selected, the new Group will appear after the the last strip of your mix desk, all the way to the
right. The default key command for “Add Group Bus” is
⇧⌥⌘G
(Shift + C G).
to customize your Group bus configuration.
Note
: Multichannel Input strips, Aux mix buses and Group buses are always created with
the same channel configuration as the Main master bus. In other words, if your Main is
configured as ‘5.1 ITU’, a new Aux, Group or multichannel Input strip will also be config-
ured ‘5.1 ITU’ to match the Main.
•
Input Strip Meters Post Fader
sets the Mixer strip meters to reflect signal level after the fader. This is
a global setting for all Mixer fader meters.
