IBM pSeries 670, Service Manual

Page: 221 / 1032

Step 152g-10
Did the system stop with the same error code as recorded in “Step 152g-1” on page 200?
Yes The book just reinserted is defective. Replace it. This ends the procedure.
Return the system to its original configuration.
Go to
″
MAP 0410: Repair Checkout
″
in the RS/6000 and
Eserver
pSeries Diagnostic Information
for Multiple Bus Systems .
No Go to “Step 152g-11”.
Step 152g-11
Have all the books listed in “Step 152g-4” on page 200 been reinserted?
Yes The symptom has changed. This ends the procedure.
Return the system to its original configuration.
Go to
″
MAP 0410: Repair Checkout
″
in the RS/6000 and
Eserver
pSeries Diagnostic Information
for Multiple Bus Systems .
No Go to “Step 152g-8” on page 200.
Step 152g-12
Turn off the power.
Examine the amber logic-power LEDs of all installed processor subsystem DCAs.
Step 152g-13
Are all amber logic-power LEDs of all installed processor subsystem DCAs off?
Yes Go to “Step 152g-14”.
No Call for support.
Step 152g-14
Pull out the following books about 25 mm (1 inch), if present:
v
Memory book 4, at location U1.18-P1-M4
v Memory book 5, at location U1.18-P1-M8
v
Memory book 6, at location U1.18-P1-M5
v Memory book 7, at location U1.18-P1-M1
Step 152g-15
Turn on the power.
Chapter 3. Maintenance Analysis Procedures
201