IBM pSeries 670, Service Manual

Page: 614 / 1032

Error Code Description Action/
Possible Failing FRU
406E 0EB9 Attention line 8 stuck fault Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406E 0EBA Attention line 9 stuck fault Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406E 0EBB Attention line 10 stuck fault Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406E 0EBC Attention line 11 stuck fault Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406E 0EBF Memory error
1. Reboot the system in slow mode to the
SMS menus. See “Performing Slow Boot”
on page 345.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v
If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
406E 0EE1 Scan control routines detected fault in service
processor code (invalid MRU to mapping)
1. Check for system firmware updates.
2. Call service support.
406E 0EE2 Scan control routines detected fault in service
processor firmware fault
1. Check for system firmware updates.
2. Call service support.
406E 0EE5 Scan control routines detected firmware error;
no callout available
1. Check for system firmware updates.
2. Call service support.
406E 25E6 SMA 4-port switch adapter fault Replace the I/O book (switch adapter) specified
by the location code.
406E 273F SMA 2-port switch adapter fault Replace the I/O book (switch adapter) specified
by the location code.
406F 0001 Error code generation/logging detected clock
card assembly failure
Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406F 0002 Error code generation/logging detected
backplane assembly failure
Go to “MAP 1540: Problem Isolation
Procedures” on page 253.
406F 0003 Error code generation/logging detected fault in
MCM module 0
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
406F 0004 Error code generation/logging detected fault in
MCM module 2
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
406F 0005 Error code generation/logging detected fault in
MCM module 1
MCM module 1 and VPD card
Location: U1.18-P1-C3 and U1.18-P1-H2.5
406F 0006 Error code generation/logging detected fault in
MCM module 3
MCM module 3 and VPD card
Location: U1.18-P1-C2 and U1.18-P1-H2.6
594
Eserver
pSeries 670 Service Guide