IBM pSeries 670, Service Manual

Page: 357 / 1032

Table 2. Firmware Checkpoints (continued)
Checkpoint Description Action/
Possible Failing FRU
E596 Read the EADS revision ID and class code
1. Replace the RIO cable specified by the
location code.
2. Replace the I/O subsystem planar to
which the RIO cable in Step 1 is
attached.
E59E End of walking bus of current EADS
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E59F End of EADS initialization
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E0 Initialize system processor array
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E1 Reserved
E5E2 Initialization of the hypervisor, phase 1
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E3 Not in quick-restart: load and set up open
firmware code in memory
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E4 Activate slave processors
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E5 Initialize the hypervisor, phase 2
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E6 Set L2 and processor status
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E7 Save I/O hub information for RTAS and
open firmware
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E8 Set up registers
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5E9 Reset the quick restart path
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
E5EE Hang state in main control code
1. Check for system firmware updates.
2. Go to “MAP 1542: I/O Problem
Isolation” on page 261.
Chapter 4. Checkpoints
337