IBM pSeries 670, Service Manual

Page: 161 / 1032

Step 1421-6
Is the PCI slot power LED of the location recorded in “Step 1421-3” on page 140 on?
NO Go to “Step 1421-7”.
YES Go to “Step 1421-12”.
Step 1421-7
Are there any empty PCI slots attached to the system that are not assigned to any partitions?
NO Go to “Step 1421-12”.
YES Go to “Step 1421-8”.
Step 1421-8
Assign the available empty and unassigned slot to the partition that will not boot.
Step 1421-9
Insert a new adapter of the same type recorded in “Step 1421-3” on page 140 into the slot assigned in
“Step 1421-8”.
Step 1421-10
Move any external cabling from the adapter in the slot recorded in “Step 1421-3” on page 140 to the
adapter in the slot assigned in “Step 1421-8”.
Step 1421-11
Attempt to boot the partition.
Does the partition boot?
NO Go to “Step 1421-12”.
YES Partition and all resources are operational. Schedule repair for the slot recorded in “Step 1421-3”
on page 140 with the customer. Go to
″
MAP 0410: Repair Checkout
″
in the RS/6000 and
Eserver
pSeries Diagnostic Information for Multiple Bus Systems . This ends the procedure .
Step 1421-12
Cannot isolate the adapter without powering off the entire system. Schedule repair for the slot recorded in
“Step 1421-3” on page 140 with the customer.
This ends the procedure .
MAP 1422: Slot is Empty Even When Populated
Step 1422-1
Record the I/O drawer and slot location of the slot that is populated with an adapter but shows empty in
the PCI hot-plug manager. Also record the adapter type.
Chapter 3. Maintenance Analysis Procedures
141