Honda NSA700A DN-1 2009, Service Manual

Page: 326 / 654

HFT
DTC 41-1 (N /D SELECT SW ITCH)
• Before starting inspection, Check fo r loose or
poor connectors on the right handlebar switch
6
P
(Gray) connector and TCM 33P (Black) connector,
then check the DTC.
1. N/D Select Sw itch Inspection
Turn the ignition switch OFF.
Disconnect the right handlebar switch
6
P (Gray)
connector.
Check fo r continuity at :he switch side right han­
dlebar switch
6
P (Gray) connector term inals in
each switch position.
Connection: N position:
Black/blue - W hite/yellow
D position:
Black/blue - W hite/blue
Is th e re c o n tin u ity ?
YES - GO TO STEP 2
NO - Faulty N/D select switch.
2. N/D Select S w itch Input Voltage Inspection
Turn the ignition switch ON and engine stop
switch " O
Measure the voltage between the right handle­
bar switch
6
P (Gray) connector of the main w ire
harness side and ground.
Connection: Black/blue (+) - Ground (-)
Does th e b a tte ry voltage exist?
YES - GO TO STEP 3.
NO - Open circuit in Black/blue wire. If Black/
blue w ire is rorm al, replace the TCM
w ith a new one, and recheck (HFT ini­
tialization procedure: page 11-93).
3. N/D Select Sw itch Line Open Circuit Inspection
Disconnect the TCM 33P (Black) connector.
Check for continuity between the right handlebar
switch
6
P (Gray) connector and TCM 33P con­
nector of the main w ire harness side.
Connection: A11 (W hite/yellow ) - W hite/yellow
A22 (W hite/blue) - W hite/yellow
TOOL:
Test probe 07ZAJ-RDJA110
Is th e re c o n tin u ity ?
YES - GO TO STEP 4.
NO - • Open circuit in W hite/yellow wire
• Open circuit in W hite/blue wire
CONNECTOR (Switch side of male terminal)
RIGHT HANDLEBAR SWITCH
6
P (Gray)
CONNECTOR (Main w ire harness side
of female terminal)
TCM 33P (Black) CONNECTOR
(Wire side of female terminal)
W hite/yellow
n
■
i
\
/
W hite/blue
<§H
A11
i i i i
.
11
r *
A22
RIGHT HANDLEBAR SWITCH
6
P (Gray)
CONNECTOR (Main w ire harness side
o f female terminal)
11-50