Honda NSA700A DN-1 2009, Service Manual

Page: 22 / 654

-
GENERAL INFORMATION
LUBRICATION & SEAL POINTS
ENGINE
MATERIAL
LOCATION REMARKS
Molybdenum
disulfide oil (a
mixture of 1/2
engine oil and 1/2
molybdenum
disulfide grease)
Rocker arm slipper surface
Rocker arm shaft outer surface
Connecting rod small end inner surface
Crankpin/journal
Camshaft lobes/journals
Valve stem (valve guide sliding surlace)
Engine oil
Piston/piston rings sliding surface
Camshaft holder bolt threads and seating surface
Piston pin outer surface
Starter reduction gear shaft outer surface
Starter one-way clutch sprag
Flywheel bolt threads and seating surface
Connecting rod bolts/nuts threads end seating surface
Cylinder head m ounting bolt/nut, seating surface
Oil filte r thread, O-ring
Oil cooler center bolt threads and seating surface
Side gear case m ounting bolt threads and seating surface
Cam damper bolt threads and seating surface
Primary driven gear bolt threads and seating surface
Cam damper sliding surface/splines
Cylinder stud bolt threads
Oil pump inside
Swash
plate angle sensor shaft journals
Cylinder 8 mm bolt threads and seating surface
Each bearings rotating area
Each gear tooth
Each O-rings
Other rotating area and sliding surface
Multi-purpose Each oil seal lips
grease
Timing hole cap
Crankshaft hole cap
Sealant (Three EOP switch threads page 5-15
Bond 1207B or
Right and left crankcase mating surface page 13-16
equivalent)
Alternator cover mating surface
page 12-12
Right crankcase cover mating surface page 11-76
Left crankcase cover mating surface page 11-64
Sealant (Three
Cylinder head cover gasket semi-circular cut-out page 9-32
Bond 5211C or
Alternator wire grom m et
equivalent)
CKP sensor wire grom m et
Locking agent
Cam sprocket bolt threads Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Starter clutch outer bolt threads
Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
CKP sensor m ounting bolt threads Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Oil separator bolt threads Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Bearing setting plate bolt threads
Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Swash plate angle sensor socket bull threads
Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Cam chain tensioner setting plate bolt threads
Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
Stator m ounting bolt threads
Coating width:
6.5 ± 1 mm (0.26 ± 0.04 mm
1-18