Honda NSA700A DN-1 2009, Service Manual

Page: 443 / 654

FINAL DRIVE
Be sure to wear
heavy gloves when
handling the heated
gear case.
Keep dust and dirt
out o f the case and
cover.
Heat the gear case cover to 80°C (176°F) evenly
using a heat gun.
NOTE:
Do not use a torch to heat the gear case cover; it
may cause warping.
Drive the bearing into the gear case cover.
BEARING
BEARING/SHIM
RING GEAR
Install the shim onto the ring gear.
Support the bearing inner race w ith the special tool
and press the ring gear into the bearing using a
hydraulic press.
TOOL:
Base 105 x 1115 x 65 mm 07ZMF-MCA0200
A pply grease to a new oil seal lips.
Install a new oil seal until it is flush w ith the cover
surface using the special tools.
TOOL:
Base 105 x 1115 x 65 mm 07ZMF-MCA0200
FINAL GEAR CASE ASSEMBLY
NOTE:
When the gear set, bearing and/or gear case has been
replaced, check the following:
• Tooth contact pattern (page 14-11)
• Gear case backlash (page 14-9).
Clean the mating surface of the gear case and cover,
being careful not to damage them.
Apply liquid sealant to the mating surface of the
gear case.
Install the shaft shim.
Install the case cover onto the gear case.
OIL SEAL
DRIVER
CASE COVER
SHAFT SHIM
14-20