Honda NSA700A DN-1 2009, Service Manual

Page: 318 / 654

HFT
2. Swash Plate Angie Sensor Resistance
Inspection
Inspect the resistance of the swash plate angle
sensor shaft groove turning.
CONNECTION: A - B
Is there resistance w ith in 0 to 1 .6 - 2.4 k£2 (20°C/
68 °FJ?
YES - GO TO STEP 3.
NO - Faulty swash plate angle sensor.
3. Swash Plate Angle Sensor Ground line
Inspection
Check for continuity between the swash plate
angle sensor connector and ground.
CONNECTION: Green/black - Ground
Is there c o n tin u ity ?
YES - Replace the TCM w ith a new one, and
recheck (HFT initialization proce-
dure:page 11-93).
NO - Open circuit in Green/black wire.
SWASH PLATE ANGLE SENSOR 3P
CONNECTOR (Wire side of female terminal)
\crt
g Green/black
4§>]
DTC 26-1 (SW ASH PLATE CONTROL
MOTOR LOCK)
• Before starting inspection, Check for loose or
poor connectors on the swash plate control
m otor 2P (Black) connector, swash plate angle
sensor 3P connector and TCM 5P (Black) connec­
tor, then check the DTC.
• When removing the swash plate angle sensor,
Perform the HFT initialization procedure (page
11-93).
1. Swash Plate Angle Sensor Installed Position
Inspection
Remove the swash plate angle sensor (page 11-
100
).
Check if the groove of the swash plate angle sen­
sor and the sensor shaft are aligned.
A re th e y in s ta lle d correctly?
YES - GO TO STEP 2.
NO - Install the position sensor correctly
11-42