Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Appendix I Ladder Diagram Usage Guide of GSK218mc Series with Cone Type Tool-Magazine
265
Appendix
operation.
Alarm information: 1271 Enforce to stop the rotation when the tool magazine abnormality (A008.7)
Fault reason: 1. The pulse signal generated from the tool magazine counting switch (X5.3) does not
detect within the T109 setting time after tool magazine delivers the rotation
command.
2. The state in the tool magazine counting switch 0 or 1 is detected and exceeds the
setting time of the T103 when the tool magazine rotates.
Troubleshooting: 1. Abnormal tool magazine positive or negative output section (Y3.0 and Y3.1).
2. Abnormal tool magazine counting switch.
3. Reset the values of the T109 and T103.
(Refer to the details operation: Section Three The Usage and Maintenance of the GSK218MC
Series with Cone Tool-magazine)
Alarm information: 1272 Abnormal spindle tool number detection (A009.0)
Fault reason: When the tool detection equipment is installed on spindle and K12.0 is set to 1, the
spindle is at the releasing/clamping state and the spindle tool number is 0, but the
system detects that the spindle is with a tool, and then perform the M06 or M50 code.
Troubleshooting: Check whether the signal of the X2.7 is normal, disassemble the tool from the
spindle, and then perform the M06 tool-change code.
Alarm information: 1273 Fail to forward because the current cutter head number is with tool
(A009.1)
Fault reason: When the tool detection equipment is installed on tool magazine and K12.0 is set to 1.
There is a tool on spindle, the system detects that the tool on the tool magazine when
performing the tool magazine forward.
Troubleshooting: 1. Check whether the signal of X5.5 is normal.
2. Readjust the tool magazine and confirm whether the tool number on the spindle
is consistent, which includes the tool magazine retraction position return,
spindle on the tool-clamping state, whether the current tool case number is
consistent with the current value of CTR100, whether the tool number on the
spindle is consistent with the value of the D245 and ensure that there is no tool
on the spindle when the value of D245 is set to 0. If they are inconsistent, it is
better perform the tool magazine zero return operation.
(Refer to the details operation: Section Three The Usage and Maintenance of the GSK218MC
Series with Cone Tool-magazine)
Alarm information: 1274 Fail to forward the tool magazine because the cutter head is not
in-position (A009.2)
Fault reason:
