Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
234
V
o
lume IV
Inst
allation
&
Connecti
o
n
12. It is better to use the spiral tapping with the dedicated coolant for cutting some soft materials
(such as the aluminum alloy, copper)
B. Flexible tapping setting: There are two methods to carry out the flexible tapping.
1. In the position control mode (that is, parameter
NO:46#1
turns into 1(servo mode),
K7#7
becomes 1 (Use the spindle position mode)), use the code M03/M04 can be carried out the
flexible tapping.
2. In the velocity control mode (that is, parameter
NO:46#1
turns into 0 (following mode),
K7#7
becomes 0 (Do not use the spindle position mode)), it also uses the M03/M04 code, which can
be carried out the flexible tapping.
During tapping, specify a tapping to the bottom of the hole in programming, it is better to dwell 1s
or 2s.
Note: The above-mentioned are corresponding to the machine setting methods of the shifting without gears.
4.16 Setting for the 4
th
Axis
GSK218MC series owns 4-axis & 4-liange function.
The data parameter P5 sets to 4; the 4
th
axis function of the system is enabled after the system
restarts again.
Relative bit parameter:
System parameter number
0
0
9
A4TP
RAB
RAB
=1: That each axis regards as the rotation axis rotates nearby
=0: That each axis regards as the rotation axis does not rotate nearby
A4TP
=1: Set it as the 4-axis linkage system
=0: Do not set it as the 4-axis linkage system
System parameter number
0
0
8
AXS4
AXS4
=1: The 4
th
axis is set to rotation axis.
=0: The 4
th
axis is set to linear axis.
System parameter number
0
5
0
SIM G90 REL
REL
=1: The relative position display setting of the index worktable: within 360°.
REL
=0: The relative position display setting of the index worktable: without 360°.
