Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter Two PLC Programming Operation
79
V
o
lume II
Operatio
n
2.6 Compilation Command
Fig. 2-6-1
The content and operation of the command list interface:
1/972:
Display the current position of the cursor and the total line number of the ladder diagram.
RUN:
The operation state of the ladder diagram.
Input:
Display the input data.
MDI mode:
Current working mode.
[Copy]:
Press this key after entering G12.1, the ladder diagram between cursor and G12.1 can
be duplicated.
[Paste]:
Paste the copied diagram to the ladder diagram.
[Deletion]:
Press this key after entering the G12.1, the ladder diagram between the cursor and
G12.1 can be deleted.
[Replacement]:
Input the replaced the signal address, then press this key, the system may
prompt whether it is replaced or replaced completely.
Y: Replaced; N: Do not replace; A: Replaced completely
[Return]:
Return to the previous menu.
The search positioning can be performed by the page-up, page-down and four direction keys on
the panel, then check the command list.
