Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Appendix II Laddar Diagram Use Guide of GSK218mc Series Matching with Disc Tool Magazine
299
Appendix
(Refer to the details operation: Section Three The Usage and Maintenance of the GSK218MC
Series with Disk Tool-magazine)
Troubleshooting: Readjust the tool magazine and confirm the tool number on the spindle is
consistent, which includes that whether the manipulator is on the origin position;
whether the tool case returns to the horizontal position; whether the spindle is on
the tool-clamping state; whether the current tool number is coincident with the
current value of the CTR100 and whether the tool number on the spindle is
different with the value of the D245.
Alarm information: 1245 There is no code tool number or the code tool number is repeated in the
tool table (A005.5)
Fault reason: There is no the specified tool number by T code in the tool table (D000-D099) or the
specified tool number by T code in the tool table is repeated.
Troubleshooting: Modify the tool number value in the tool table.
Alarm information: 1246 Spindle tool releasing/clamping detection abnormality (A005.6)
Fault reason: The spindle tool is neither at the releasing position nor at the clamping one.
Troubleshooting: Check whether the X2.5 and X2.6 are normal.
Alarm information: 1247 Spindle orientation time-sequence detection abnormality (A005.7)
Fault reason: The spindle orientation is firstly performed before the spindle does not orientate.
Troubleshooting: Check whether the signal of the X7.1 is normal.
Alarm information: 1248 Inadequate condition of the T code tool number (A006.0)
Fault reason: Fail to complete the 1
st
T code tool number, but the 2
nd
one is performed.
Troubleshooting: Perform the 2
nd
T code tool number after the 1
st
one is absolutely completed.
Alarm information: 1249 Fail to infeed because the spindle is with the cutter (A006.1)
Fault reason: Z axis is on the origin position and the spindle is with cutter (D245 is not treated as 0),
the tool magazine infeed is then performed.
Troubleshooting: Disassemble the cutter on the spindle, and then set the D245 to 0.
Alarm information: 1250 Fail to infeed, because the current tool No. is different with the spindle
(A006.2)
Fault reason: Z axis is at the tool-change position, the tool number on the spindle is inconsistent with
the one of the tool magazine in the current tool case, and then perform the tool
magazine infeed.
