Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
278
Appendix
and when the tool magazine is at the forward limit position; the spindle has been released the tool,
and Z axis will lift but hold it, or the Z axis does not rotate the cutter head yet after lifting, it should be
used continuously if the ESP, OFF & Alarm, RSET are generated; Press the “Tool-releasing” button
on the spindle in the Manual mode, so that the tool is on the releasing state, and then lift up the Z axis
in the Manual or MPG mode to the safety position; retreat from the tool magazine by
on the
system. (Notice: The tool magazine position of the current spindle is installed with the tool, but there
is no tool on the spindle, the system should be display “T0000”), and therefore, the system can be
normally used.
3. When the tool-change specified in MDI mode or the tool-change method in the Auto mode,
and when the tool magazine is at the forward limit position; the Z axis is already lifted at the 1
st
reference point; The current tool number may inconsistent with the actual one if the ESP, OFF &
Alarm and RESET when the cutter head is being rotated. The system alarm occurs: “1218 Confirm
the tool number again because the tool magazine abnormally stops” or “1244 Ensure the tool
magazine is normal when tool-change abnormality stop” etc. If you want to use it continuously, retreat
from the tool magazine by the
on the system in the Manual mode; the system can be used
normally after the tool magazine zero return again and after the spindle and tool magazine tool
numbers are reset. (Refer to the Section Three The usage and maintenance with the cone tool
magazine for the GSK218MC CNC system).
IV. The Macro Note Matching with the Cone Tool Magazine
O91001
；
(Program name)
G65 H81 P50 Q#1003 R1
；
(Miscellaneous lock, machine lock, rotate the N50 program to
the end when spindle tool number =T code tool number)
G65 H81 P30 Q#1002 R1
；
(Rotate the N30 instead of executing the tool-searching code
when T code tool number=0)
G69 G50 G15 G80 G40
；
(Cancel the relative modal)
M50
；
(Tool-change begins, check whether the tool-change is
suitable, if does not, the alarm may occur)
G65 H81 P20 Q#1000 R1
；
(Spindle tool number=0 that is, without tool on the spindle,
rotate the N20 instead of performing the tool-return code)
M19 G00 G91 G49 G30 Z0
；
(Spindle positioning, return to the tool-change coordinate
point)
