Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC & Installation Connection Manual
72
Volume II
Operatio
n
CHAPTER TWO PLC PROGRAMMING OPERATION
2.1 Brief
The PLC operations of the GSK218MC serial are completed corresponding interface in the
system. The overall modification of the ladder diagrams should be performed after gaining the
limitation higher than the debugging.
GSK218MC series operations can be performed within two interfaces.
1. Enter PLCGRA classification interface pressing
[PLCGRA]
twice, refer to the
Fig. 2-1-1
:
The
PLCGRA
interface consists of basis code, function code, command table and edit
command.
Fig. 2-1-1
2.
PLCPAR
interface includes KPAR, TMR, DATA, CTR and MDEC.
Enter PLCRAR interface pressing the
[PLCPAR]
soft key, refer to Fig. 1-2-3-1. Enter the
PLCPAR classification operation interface by controlling
[PLCRAR]
again, refer to the Fig. 2-1-2.
The parameter modification, PLC operation state control and entering the I/O debugging mode
should be performed after the limitation above the debugging is gained. Refer to the Chapter Three
for details.
