Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
272
Appendix
Add.
Definition
State 0
State 1
K010.5
Whether the tool magazine counting switch is selected the NC
type
NORM NC
For example:
There is one tool magazine is without zero return switch, other detection
switches are NORM, and its corresponding parameters are set as: K010.1=0 K010.2=0
K010.3=0 K010.4=0 K010.5=0.
D. The setting of the tool magazine capacity
Input the tool magazine capacity in the DATA100 and CTR100.
Precautions:
1. Tool magazine capacity is the tool case numbers in the tool magazine.
2. The setting value both DATA100 and CTR100 should be less than 100.
For example:
When the tool magazine capacity is 16, set the DATA100 to 16, CTR100 to 16.
E. The setting of tool number in the tool magazine:
D001--D099 in the data table are separately corresponding to the No.1—No.99 tool case in the
tool magazine, and the setting in the D001--D099 data table are separately corresponding to the tool
number No.1-No.99 of the tool case in the tool magazine, D245 is the tool number on the spindle.
Precautions:
1. Same tool number (other than 0) in the D001--D099 can not be set, otherwise, the system
alarms when performing the tool-change.
2. The setting range of the tool number should be available for the setting requirement of the
data parameter 0206; otherwise, the system alarms when performing the T code.
For example:
When the tool magazine capacity is 16:
If set the 1—16 as the D1—D16 in turn, when performing the T8 M6, the No.8 tool case
will perform the tool change after rotating to the tool-change position;
If set the 0, 20, 30……160 as the D1—D16 in turn, when performing the T8 M6, the No.8
tool case will perform the tool change after rotating to the tool-change position;
If both the D1 and D2 are set to 8, the system may alarm when performing the T8 M6.
F. The time parameter (TMR) setting related with the tool magazine
Add. Note
Setting
range
Initial value
(ms)
T004
Spindle positioning completion delayer
Greater than or equal to 0
0
