Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Chapter Two PLC Programming Operation
75
V
o
lume II
Operatio
n
z
Insertion component: Positioning the cursor to the place where is required to insert the
component; a vacancy is inserted in this place pressing the
key, and then add the
new component pressing the steps of the add component. The cursor can be inserted in
turn.
z
Component Deletion: Delete the current component pressing the
key on the
panel.
z
Add the vertical breakover cable: Add a vertical breakover cable at the lower right corner of
the current cursor by pressing the
[ ]
soft key.
z
Delete the vertical breakover cable: The vertical breakover at the lower right corner of the
current cursor can be deleted by pressing the
[ ]
soft key.
z
Add a horizontal breakover cable: a horizontal breakover cable can be inserted at the
current cursor place by pressing the [
——]
soft key; the horizontal breakover cable may
replace the component which has been performed at the current position.
z
Row insertion: The cursor is positioned at any destination row, firstly press the
on
the panel, then press the
key, and therefore a new row is inserted above the
specified row of the cursor. The followings rows are moved down in turn.
z
Row deletion: The cursor is positioned at the destination row, firstly press the
on
the panel, then press the
key, the current row is then deleted, the following rows
are moved up in return.
z
Block deletion: The cursor is positioned as the start position where to be deleted, then input
the address of the output coil of the desired deletion block, and then press the
key on the panel.
z
Search: Directly input the component name what you want to reach, it will display at the
