Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC & Installation Connection Manual
88
Volume II
Operatio
n
then start the corresponding ladder diagram network. The system alarm occurs after modifying, the
prompt content is “Cut off the power”, and its setting is enabled after the system is restarted. The
setting of the M function in PLC program, its corresponding M code is desired to be used after the
corresponding address is modified, the ladder diagram is then modified. It is necessary to operate
carefully, so that the machine may be damaged or the injury accident may occur.
The search and positioning can be performed by the page-up, page-down and four direction
keys on the panel; the M function corresponding to the F address can be checked or modified.
Note 1:
M00, M03, M04 and M05 can not be changed because they are occupied by the system.
Note 2:
The file numbers of the ladder diagram and configuration should be consistent when the system is
performed the ladder and configuration files. The data after modifying are stored to the configuration file of
corresponding current ladder diagram file number. User should compile its significance of the signal in this
configuration file, so that the system can be correctly displayed the modified information from the user. The
Chinese note name of the configuration is “LadChixx”, and the English note name is “LadEngxx”.
