GSK GSK218MC, User Manual

Page: 248 / 336

Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
232
V
o
lume IV
Inst
allation
&
Connecti
o
n
=0:The gear ratio of the spindle and the position encoder can not be
random.
DOV =1: The override is enabled during the rapid tapping retraction.
=0: The override is disabled during the rapid tapping retraction.
PCP =1: The tapping is high velocity deep peck tapping cycle.
=0: The tapping is standard deep peck tapping cycle.
System parameter number
0 4 5 OVS OVU TDR NIZ
NIZ =1: Perform the smooth processing for rigid tapping
=0: Do not perform the smooth processing for rigid tapping
TDR =1: Use the identical time constant when the rigid tapping performs
infeed/retraction.
=0: Do not use the identical time constant when the rigid tapping performs
infeed/retraction.
OVU =1: Rigid tapping retraction override 10%
=0: Rigid tapping retraction override 1%
OVS =1: The feedrate override selection and override cancellation signal in the
rigid tapping are enabled.
=0: The feedrate override selection and override cancellation signal in the
rigid tapping are disabled.
System parameter number
0 4 6 ORI SSOG
SSOG =1: The spindle control mode is servo when the tapping starts.
=0: The spindle control mode is follow when the tapping starts.
ORI =1: The spindle performs the exact stop when tapping starts.
=0: The spindle does not perform the exact stop when tapping starts.
K parameter number
0 0 7 PAP
DGN =1: Use the spindle position mode.
=0: Do not use the spindle position mode.
It is set to 1 when using the rigid tapping, and set to 0 when using the
flexible tapping.