Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
Appendix II Laddar Diagram Use Guide of GSK218mc Series Matching with Disc Tool Magazine
281
Appendix
APPENDIX II LADDAR DIAGRAM USE GUIDE OF GSK218MC
SERIES MATCHING WITH DISC TOOL MAGAZINE
I. The application precautions of the disc tool magazine
1) Confirm each operation should be executed during tool-change, and then the next operation
can be performed.
2) Do not perform the tool-pivoting before the tool magazine positioning inductor does not
confirm.
3) Fail to start the motor of the tool magazine and rotate the cutter head if the tool-pivoting does
not complete during performing.
4) Do not perform the tool-change before the tool-pivoting does not confirm.
5) Do not perform the tool-change when the machine spindle does not return to the tool-change
point.
6) Do not perform the tool-change before the spindle positioning does not perform.
7) Fail to complete the tool-change operation, and do not move the spindle head before the tool
arm does not return to the origin.
8) The overload protective relay should be firstly turned off avoiding the motor being burnt.
9) It is better to perform the tool-change with the manual method firstly, after checking the
tool-case pivoting, tool-change mechanical operation and spindle tool-releasing/clamping, etc.
are correct, and then perform the CNC automatic sequence program control.
10) Only the input/output signal (X and Y address) should be modified in the ladder diagram
programming during debugging, the debugging requirement then can be completed. Do not
modify others without any assurance to prevent the accident from generating.
II. The Configuration and Definition of the PLC I/O Address and
Internal Soft Component
Table 1 The definition of input signal interface
Add.
Signal
interface
Interface
pin
Definition
Contactor
selection
X000.0
XS40
1
+ stroke limit signal along with the 1
st
axis
NC contactor
X000.1
XS40
14
- stroke limit signal along with the 1
st
axis
NC contactor
