Official GSK Agents in South Africa
Tel: +27 11 626 2720, [email protected]
GSK218MC Series Machining Center CNC System PLC&Installation Connetion Manual
128
V
o
lume
III Function
Signal output
The signal
completion
of the
shifting
Response
signal
Function
Program
address
F address
signal
Strobe
signal
End signal
S code
miscellaneo
us function
S****
(F034#0~#2)
TF
(F007
＃
2
）
GRAR
(G002#4
）
SRESP
(G063#1)
FIN(G000#0)
SFIN(G000#4)
The S code miscellaneous function explanations are shown below:
(1) It is supposed that the SXXXX is specified in program: (The state of F34#0~#2 is determined
by parameter P246~248, and PLC can be performed the processing of the gear step change
by this signal, for example, the parameter P246 is set to 1000, and S500 executes).
(2) If the non M, S and T codes, such as the movement and dwell, are specified with the
miscellaneous function at the same time, the
miscellaneous
function is then simultaneously
performed.
(3) When the S500 is performed, the F address signal F34#0 and the strobe signal F007#2 are set
to 1, simultaneously, ensuring the PLC sets the response signal SRESP(G063#1) to 0
(4) The PLC is set the gear shift signal GRAR (G002#4) is set to 1 when the gear shift is
completed.
(5) PLC is set the end signal SFIN (G000#4) and FIN (G000#0) to 1 when the S code
miscellaneous function is performed. If these code miscellaneous functions, namely, M, S and
T, are performed simultaneously, the end signal FIN (G000#0) can be set to 1 till all of these
functions are executed.
(6) When the S500 is completed, ensuring the PLC is set the response signal SRESP (G063#1) to
1.
(7) M, S and T codes may be performed simultaneously in a block. The CNC can be performed
next block after affirming the end signal FIN is set to 1.
7.3 T Code Miscellaneous Function
Brief
T code miscellaneous function: T code should be used with the M code together, for
example:T06M06;
When the T code is performed, the data address (D241) and the strobe signal are sent to
PLC, and PLC starts or cut off its relative functions using these signals.
Basis process
These signals are used for the following functions
