Fuji Xerox Versant 80 Press, User Manual

Page: 715 / 1019

Fold Position Adjustment
715
M
a
int
e
na
nc
e
21
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note •
When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
Z Fold Half Sheet Position Adjustment
1
Select [Z Fold Half Sheet - A3 ], [Z Fold Half
Sheet - B4 ], [Z Fold Half Sheet - 11x17" ],
or [Z Fold Half Sheet - 8K ], and then select
[Change Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4
Select [Close].
5
Check the printed sample printout, and measure the A
and B fold position movement amounts.
6
Enter the value you measured in step 5 in
[Values A & B Before Adjustment], and the
value to which to adjust in [Desired Values A &
B].
Important • Set value B so that an edge of the paper does
not extend beyond a fold position of the
paper. Extending an edge of paper beyond a
fold position of the paper may cause a paper
jam.
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.