Fuji Xerox Versant 80 Press, User Manual

Page: 667 / 1019

Replacing Consumables
667
M
a
int
e
na
nc
e
21
Replacing the Staple Cartridge
When the optional finisher is installed and it is time to replace the staple cartridge, a
message appears on the touch screen. When the message appears, replace the staple
cartridge with a new one.
The following shows the reference section.
When the Finisher C3 or the Finisher C3 with Booklet Maker is installed ......................................................................667
When the Finisher D4, the Finisher D4 with Booklet, or the Finisher D5 is installed ...................................................668
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
• If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
When the Finisher C3 or the Finisher C3 with Booklet Maker is installed
The following describes how to replace a staple cartridge for the Finisher C3 with Booklet
Maker as an example. The procedure is the same as for the Finisher C3.
1
Make sure that the machine is not operating,
and open the finisher front door.
2
With grasping the lever [R1] of the staple
cartridge holder, pull the holder to the right,
towards you.
3
With grasping the orange lever, pull out the
staple cartridge.
Note • The staple cartridge is firmly inserted. A slight
force is required to pull the cartridge out of
the finisher.