Eaton ELC-PB, Programming Manual

Page: 569 / 728

E L C P r o g r a m m i n g M a n u a l
F o r m o r e i n f o r m a t i o n v i s i t : w w w. e a t o n . c o m M N 0 5 0 0 3 0 0 3 E
3 - 4 0 0
b) Settings for absolute position and operation speed: (D1343 (D1353) is the
acceleration/deceleration time setting of the first step acceleration and last step
deceleration of Y10(Y11). D1340 (D1352) is start/end frequency setting of Y10 (Y11)).
Acceleration
slope
accel/decel time accel/decel time
Current
position
Acceleration
sampling time
Output pulse
frequency
First acceleration segment
Y10 (D1340)
Y11 (D1352) Min: 100Hz
Default: 200ms
Y10 (D1343)
Y11 (D1353)
Default: 200ms
Y10 (D1343)
Y11 (D1353)
Last deceleration segment
Y10 (D1340)
Y11 (D1352)
Min: 100Hz
Output pulse
numbers
3. When this instruction is OFF and the output is not complete:
If M1334=ON, Y10 will stop the pulse output immediately.
If M1334=OFF, Y10 will decelerate from the deceleration time to the end frequency and then
stop the pulse output.
It is the same way for M1335 with respect to Y11 output.
4. Please refer to the DDRVI instruction: “Remarks for flag information.”
5. Wiring for the ELC-PH12NNDT series and the Servo Drive