Eaton ELC-PB, Programming Manual

Page: 403 / 728

E L C P r o g r a m m i n g M a n u a l
F o r m o r e i nf o r m a t i o n v i sit :
w w w. e a t o n . c o m
MN05003003E
3-234
M1130
0 1
0
D1124: user defined
D1125: user defined
D1126: user defined
D1124: H 0002
D1125: H 0003
D1126: H 0000 (no setting)
M1
12
6
1
D1124: user defined
D1125: user defined
D1126: user defined
D1124: H 003ª (’:’)
D1125: H 000D (CR)
D1126: H 000A (LF)
7. Example of setting communication format in D1120:
Communication format:
Baud rate: 9600, 7, N, 2
STX: “: “
ETX1: “CR”
ETX2: “LF”
Check to the table in point 4 and the set value H788 can be referenced corresponding to the
baud rate. Set the value into D1120.
b15 b0
0 0 0 0 0 1 1 1 1 0 0 0 1 0 0 0
7 8 8
D1120
0
N/A
MOV H788 D1120
M1002
When STX, ETX1 and ETX2 are applied, care should be taken on setting the ON/OFF status
of M1126 and M1130.
8. D1250(COM1)
、
D1253(COM3) communication error code:
Value Error Description
H0001 Communication time-out
H0002 Checksum error
H0003 Exception Code exists
H0004 Command code error / data error
H0005 Communication data length error
9. Corresponding table between D1167~D1169 and the associated interrupt pointers. (Only
lower 8 bits are valid)