Eaton ELC-PB, Programming Manual

Page: 346 / 728

3 . I n s t r u c t i o n S e t
M N050 03003E F or mo re infor ma tio n vi sit:
w w w. e a t o n . c o m
3-177
Flag explanation:
M1040:
Step point movement disabled. When M1040=ON, all movements of the step point are disabled.
1.
Manual operation mode:
M1040 = ON.
2.
Zero point return mode/one cycle operation mode:
Pressing the STOP button and pressing
START button again, M1040 = ON.
3.
Step operation mode:
M1040 = ON, and will only be OFF when the START button is
pressed.
4.
Continuous operation mode:
When ELC goes from STOP
→
RUN, M1040 = ON, and will be
OFF when the START button is pressed.
M1041:
Step point movement start. the special auxiliary relay that reflects the movement of the primary step
point (S2) to the next step point.
1.
Manual operation mode/Zero point return mode:
M1041 = OFF.
2.
Step operation mode/One cycle operation mode:
M1041 = ON when the START button is
pressed.
3.
Continuous operation mode:
Stays ON when the START button is pressed, and turns OFF
when the STOP button is pressed.
M1042:
START pulse: Only once pulses will be sent out when the button is pressed.
M1043:
Zero point return complete: Once M1043 =ON, indicates that the RESET motion has been
executed.
M1044:
Conditions of the origin: In continuous operation mode, conditions of the origin, M1044= ON to
execute the initial step point (S2) moving to the next step point.
M1045:
All output reset inhibit. If executing conditions:
1. From manual control S0 to zero point return S1
2. From auto operation S2 to manual operation S0
3. From auto operation S2 to zero point return S1
a) When M1045=OFF and one of S of
D
1
~
D
2
is ON, step point of SET Y output and actions
will be cleared to OFF.
b) When M1045 =ON, SET Y output will be reserved, and step point during action will be
cleared to OFF.