install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
FLINT
V1.1
7.7.3 Setting Camera Numbers for Hitachi Camera Control
After installation is complete, you need to set the address of each Pan/Tilt head. All
Eagle Pan/Tilt heads are set at the factory to have the addresses remotely
programmed. If you have trouble with anything in this section, go to the Display Devices
Operations and Instruction Manual and be sure your head is set to remote address
control.
To assign numbers to each camera:
1.
Create a Broadcast Pix show, as described in section 3.
2.
Add camera control to that show, as described in section 7.8.
3.
Decide what address each Pan/Tilt Head is going to be. In order to set the address of
the head, the panel sends out a command to all connected heads. So in order to get
the correct address to just one head, all of the other heads not being programmed
need to be powered down, by unplugging them.
4.
On the control panel, press the
[Hitachi Camera Control]
device button, and then
the PixPad will show 9 Cameras. For this operation it makes no difference which one
you press, so press any one of the nine.
5.
On the next PixPad press
[Settings]
. On the next PixPad press the
[Cam Cntrl]
.
On the next PixPad press
[Next]
. On the next PixPad press
[Next]
, and you should
arrive at the following PixPad:
7.7.3