B&R ACOPOSinverter P84, User Manual

Page: 99 / 405

Programming guidelines
ACOPOSinverter P84 User's Manual 2.10 99
2.5.4 Adaptation and extension of functions by the user
• You can change the settings and extend the functions described on the following pages via the display
and the buttons.
•
The factory settings can be easily restored via the menu
[FACTORY SETTING]
(FCS-) ( see "[FACTORY
SETTINGS] (FCS-)" on page 314 ).
•
There are three types of parameters:
– Display: Values displayed by the frequency inverter
– Setting: Parameters that can be modified during operation or when the motor is stopped
– Configuration: Can only be changed when the motor is stopped and no braking is taking place. Can
be displayed during operation
Warning!
RISKS OF ACCIDENTAL DEVICE OPERATION
•
Make sure that changes to settings during operation do not cause any hazards.
•
We recommend stopping the frequency inverter before making any changes.
Failure to follow these instructions will result in death or serious injury.
2.5.5 Starting the device
Important:
• In the factory-default state, the engine can be supplied with power only after the commands "Clockwise
rotation", "Anti-clockwise rotation" and "Stop run by DC injection" have been reset:
➯ When turning on, at a manual error reset or after a stop command
If these commands have not been reset, the inverter indicates the message "nSt" and cannot be
started.
•
If the function for automatic restart has been configured (parameter
[Aut. restart]
(Atr) in the menu
[ERROR MANAGEMENT]
(FLt-) , see "AUTOMATIC RESTART (Atr-)" on page 290 ), then these com-
mands are taken into consideration and a reset is not required.
2.5.6 Firmware of the 8I0IF248.300-1
The firmware is a component of the automation runtime. The module is updated to this version automatically. In
order to update the firmware included in Automation Studio, a hardware upgrade must be performed (see the
"Project management - Upgrade from Automation Studio" in Automation Help).