B&R ACOPOSinverter P84, User Manual

Page: 149 / 405

Programming guidelines
ACOPOSinverter P84 User's Manual 2.10 149
Code Name/Description Setting range Factory settings
bEt [Brake engage time] 0 to 5.00 s 0 s
see "[BRAKE LOGIC CONTROL] (bLC-)" on page 223 .
Brake engage time (brake response time)
JdC [Jump at reversal] [Auto] (AUtO)
0 to 10 Hz
[Auto] (AUtO)
see "[BRAKE LOGIC CONTROL] (bLC-)" on page 223
ttr [Time to restart] 0.00 to 15.00 s 0 s
see "[BRAKE LOGIC CONTROL] (bLC-)" on page 223 .
Delay between the end of a brake engage sequence and the start of a brake release sequence
tLIM [Motoring torque lim] 0 to 300% 100%
see "LIM. TORQUE (tOL-)" on page 258 .
Torque limiting for generator operation in percent or 0.1% of the rated torque in accordance with the parameter [Torque limit. activ.] (IntP) .
tLIG [Gen. torque lim] 0 to 300% 100%
see "LIM. TORQUE (tOL-)" on page 258 .
Torque limiting for generator operation in percent or 0.1% of the rated torque in accordance with the parameter [Torque ref. assign.] (IntP) .
trH [Traverse freq. high] 0 to 10 Hz 4 Hz
see "TRAVERSE CONTROL (trO-)" on page 282 .
trL [Traverse freq. low] 0 to 10 Hz 4 Hz
see "TRAVERSE CONTROL (trO-)" on page 282 .
qSH
[Quick step High]
0 to
[Traverse HSP]
(trH)
0 Hz
see "TRAVERSE CONTROL (trO-)" on page 282 .
qSL [Quick step Low] 0 to [Traverse LSP]
(trL)
0 Hz
see "TRAVERSE CONTROL (trO-)" on page 282 .
Ctd [Current threshold] 0 to 1.5 In
1)
In
1)
Current threshold value of the function [thresh. I err.] (CtA) , that is assigned to a relay or a logic output, see "R1 CONFIGURATION" on page 176 .
ttH [High torque thd.] -300 to 300% 100%
Upper torque threshold value of function [high torque alarm] (ttHA) that is assigned to a relay or logic output, see "R1 CONFIGURATION" on
page 176 .
ttL
[Low torque thd.]
-300 to 300% 50%
Lower torque threshold value of function [Low torque alarm] (ttLA) that is assigned to a relay or logic output ( see "R1 CONFIGURATION" on
page 176 ) as a percentage of the nominal torque
1) In is the same as the rated current specified in the installation instructions or on the nameplate of the inverter.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can also be
accessed and adjusted from within the configuration menu for the corresponding function, their description is detailed in these menus, on
the pages indicated, to aid programming.