B&R ACOPOSinverter P84, User Manual

Page: 94 / 405

Programming guidelines
94 ACOPOSinverter P84 User's Manual 2.10
2.2 Steps for setting up
INSTAL-
LATION
1 Read the installation instructions
PROGRAMMING
Usable procedure if the factory configuration and the use of the [SIMPLE START] (SIM-) menu is sufficient for the application.
2 Apply input power but do not give a start command
• For instructions on how to use a separate power supply for the control unit see "Separate voltage supply of the control
unit" on page 98
3 If the inverter has a graphic display terminal, select the language
4 Configure the menu [SIMPLE START] (SIM-)
• 2 or 3-wire control
• Macro configuration
• Motor parameters
➯ Perform an autotuning.
• Nominal thermal current
• Acceleration and deceleration ramps
• Speed variation range
5 Start
Tips:
• Before programming, fill out the tables see "Tables with user-specific settings" on page 340 with user-specific settings
• Perform an autotuning to optimize performance, see "Overview of parameters [SIMPLE START] (SIM-)" on page 127
• In the event of a fault, restore factory settings, Factory setting parameters (FCS1 - SCS1)
Note:
Check that the wiring of the inverter is compatible with its configuration.