ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 73 / 272

INSTALLATION
Page4-18
D) Strip back the PVC jacket to within 1/2 inch
(12,7mm) of the enclosure.
E) Clip the shield wire to 3/4 inch (19,1mm) of length.
F) Pull back the shield wire and solder to a 2 1/2 inch
(63,5mm), 18 AWG, green/yellow wire as shown in
Figure 4-26:.
G) Slide a 1 inch (25,4mm) section of heat-shrink over
the soldered connection and shrink.
H) The termination point on TB8 depends on the type of
engine to which the Processor is interfacing. The fol-
lowing table lists the termination points.
4-5 E
NGINE
S
TOP
S
WITCHES
An engine stop switch(s) must be located at all Remote Stations and
capable of stopping the engine at any RPM. Refer to the installation
instruction supplied with the switch and the engine installation instruc-
tions for manufactures recommendations.
4-6 P
USH
-P
ULL
C
ABLE
C
ONNECTIONS
4-6.1 Processor
A) Remove the #10-32 jam nut and the two rubber seals from the
end of each push-pull cable that is to connect to the Proces-
sor(s) only; discard the seals, but save the nuts.
Figure 4-26: Engine Shield
Table 4-8: Throttle Termination Table
Throttle Type Termination
DC Voltage (0 to 5.0 VDC) Signal- TB8-5, Return- TB8-7
Current (4.0 to 20.0 mA.) Signal- TB8-4, Return- TB8-7
PWM (0 to 99%) Signal- TB8-3, Return- TB8-7
Frequency ( Signal- TB8-6, Return- TB8-8
Idle Validation (+)- TB8-1, (-)- TB8-2
WARNING: A
N
E
NGINE
S
TOP
S
WITCH AT EACH
R
EMOTE
S
TATION IS AN ABSOLUTE REQUIREMENT
.
R
EFER TO
CFR 46, SEC. 62.35-5
AND
ABYC P-24.5.8.
2.5 inch (63,5mm) of
18 AWG, Green/Yellow Wire
.38
inch
(9,65mm)
Solder Wire
to Shield
Cable
Heat Shrink
.75 inch (19,1mm)
of Cable Shield
12286