ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей, Страница: 41 / 272

OPERATION
Page 2-16
2-13.4 Clutch Solenoid Tones
2-13.4.1 One Long - One Short Tone
Detail information on this tone is in Appendix B.
This tone indicates that a fault was detected with either the
Ahead or Astern Clutch Solenoid.
2-13.5 Troll Integrated Servo (Servo 1) Tones
The following Tones are in addition to the Basic Tones listed in
Section 5-6.4.1, page 5-29
2-13.5.1 One Long - One Short Tone
Detail information on this tone is in Section B5-2.1,
page B5-6.
This tone indicates that the feedback potentiometer signal
from Servo 1 (Troll) has gone out of range.
2-13.5.2 One Long, One Short -High Repetitive RateTone
Detail information on this tone is in Section B5-2.2,
page B5-6.
This tone indicates that Servo 1 (Troll) cannot reach the
commanded position. This tone is also referred to as Servo
1 Jam Tone.
2-13.6 Troll Integrated (Servo 2) Tones
The following Tones are in addition to the Basic Tones listed in
Section 2-12.1, page 2-40
2-13.6.1 One Long - Two Short Tones
Detail information on this tone is in Section B5-3.1,
page B5-7.
This tone indicates that the feedback potentiometer signal
from Servo 2 (Troll) has gone out of range.
2-13.6.2 One Long, Two Short - High Repetitive Tone
Detail information on this tone is in Section B5-3.2,
page B5-8
This tone indicates that Servo 2 (Troll) cannot reach the
commanded position. This tone is also referred to as Servo
2 Jam Tone.
Figure 2-24: One Long - One Short Tone
Figure 2-25: One Long - One Short Tone
Figure 2-26: One Long, One Short - High Repetitive Rate Tone
Figure 2-27: One Long - Two Short Tones
Figure 2-28: One Long - Two Short - High Repetitive Tones