ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей, Страница: 187 / 272

TROUBLESHOOTING
PageB2-2
One Long- Three Short Tones
(Refer to Section B5-1.2,
page B5-2)
Steady Tone
(Refer to Section B5-1.3, page B5-4)
Three Second Steady Tone
(Refer to Section B5-1.4,
page B5-4)
Five Seconds On, Five Seconds Off - High Repetitive Rate
Tone
(Refer to Section B5-1.6, page B5-5)
Five Second Steady Tone
(Refer to Section B5-1.7, page B5-
5).
The following tones can be produced on all Systems utilizing
Servo 1:
One Long, One Short - High Repetitive Rate Tone
(Refer to
Section B5-2.2, page B5-6)
One Long - One Short Tone
(Refer to Section B5-2.1,
page B5-6)
The following tones can be produced on all Systems utilizing
Servo 2:
One Long - Two Short Tones
(Refer to Section B5-3.1,
page B5-7)
One Long, Two Short - High Repetitive Rate Tones
(Refer
to Section B5-3.2, page B5-8)
The following tone can be produced on all Systems using Sole-
noid Clutches:
One Long - One Short Tone
(Refer to Section B5-2.1,
page B5-6)
E) Are there any Error Messages displayed on the
Processor’s Display LED?
•
In addition to generating a tone, at any time the system detects a
malfunction or fault, an error message will be displayed at the
Processor. Refer to Table B8-4:, Basic Control System Error
Codes, page B8-3, for an explanation of the errors.
F) What is the status of the Control Head in com-
mand’s red LED?
The red LED(s) will be in one of the following states:
Lit Steady
When the red LED is
Lit Steady
, this indicates that the Sta-
tion is in command and in Normal operative mode.
Not Lit
When the red LED is
Not Lit
, that Station is not in com-
mand, or there is no power to the Control System.
Blinking Slowly
A
Slow Blinking
red LED indicates that the Control Head is
in Throttle Only Mode (Warm-up Mode).