ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 65 / 272

INSTALLATION
Page4-10
J) Clip the Shield wire so that it is flush with the Clamp.
K) Connect the conductors to the appropriate pins as
shown on Table 4-2:, using a small slotted screwdriver as
shown in Figure 4-14:
L) Connect the other station's seven-conductor cables to
the appropriate station terminal strips in the same way.
4-4.6.2 Start Interlock Cable (Location 4)
4-4.6.2.1 Connection at the Starter Solenoid
A) Run the length of two-conductor cable between
the Engine’s Starter Solenoid and the Processor.
B) Disconnect the Starter Switch wire from the Sole-
noid.
C) Strip back the appropriate amount of PVC jacket-
ing and conductor insulation.
D) Connect one of the conductors to the Solenoid’s
Starter Switch terminal.
E) Butt splice the second wire to Starter Switch
wire.
4-4.6.2.2 Connection at the Processor
A) Install a liquid tight connector into entry hole
(No. 4). (
Refer to Figure 4-5:, page 4-10, for
entry hole location and Figure 4-4:, page 4-
10, for cable grip installation
.)
B) Run enough of the two-conductor power cable
through the liquid tight cable grip so that it can
Figure 4-14: Terminal Strip Cable Connections
Table 4-2: Processor Circuit Board Terminal Strip Color Coded Connections for Remote
Stations
Conductor Color Processor Termination Left Hand Control Head Right Hand Control Head
Black Station 1 thru 5, Pin 1 Pin 1 Pin 1
Brown Station 1 thru 5, Pin 2 Pin 2 Pin 2
Red Station 1 thru 5, Pin 3 Pin 3 Pin 3
Orange Station 1 thru 5, Pin 4 Pin 4 Pin 4
Green Station 1 thru 5, Pin 6 Pin 6 Pin 6
Blue Station 1 thru 5, Pin 7 Pin 5 Pin 7
Violet Station 1 thru 5, Pin 8 N/C Pin 8
Jumper between Pins 3 and 7. Jumper between Pins 3 and 5.
12261