ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 31 / 272

OPERATION
Page 2-6
Refer to Figure 2-11: when selecting between Low and High Idle
(or vice versa) at the Station-in-Command.
2-10 O
NE
L
EVER
M
ODE
(T
WIN
S
CREW
)
The system supports a mode of operation referred to as One Lever
Mode, which allows the operator to control both engines and
clutches with a single Control Head lever. The Port or the Star-
board lever at any Remote Station can be designated by the opera-
tor as the
Master lever
. The designation can be changed by the
operator at any time. Most of the features (synchronization, troll,
etc.) available in normal operation are available while operating in
One Lever Mode.
• The Processor defaults to One Lever Mode disabled.
• One Lever Mode can be disabled or enabled in the Set Up Proce-
dures.
• When One Lever Mode is enabled, the operation must be turned
ON and OFF as described below.
2-10.1 Turning ON One Lever Operation
Figure 2-11: High/Low Idle Mode Selection
A) The Control Head’s lever(s) may be in
the Neutral, Ahead or Astern detents
when making a selection.
B) Depress and hold the transfer button
for 1/2 second and then release.
• If the System was in Low Idle it will
toggle to High Idle, and vice versa.
C) To return to the previous Idle setting,
depress and hold the transfer button
again for 1/2 second and then
release.
NOTE: I
N
T
WIN
S
CREW APPLICATIONS
,
ALWAYS PROGRAM BOTH
P
ROCESSORS FOR THE SAME AMOUNT
OF
H
IGH
I
DLE
. I
N
T
WIN
S
CREW APPLICATIONS
,
BOTH THE
P
ORT AND
S
TARBOARD
P
ROCESSORS
WILL ALWAYS BE IN
H
IGH OR
L
OW
I
DLE AT THE SAME TIME
.
NOTE: O
NE
L
EVER
O
PERATION MAY BE USED IN
T
ROLL
M
ODE OR IN
N
ON
-T
ROLL
M
ODE
.
NOTE: T
HE
G
REEN
LED
WILL ALWAYS BE LIT WHILE IN
O
NE
L
EVER
O
PERATION
,
NO MATTER WHAT
POSITION THE
M
ASTER
C
ONTROL
H
EAD LEVER IS IN
.
WARNING: P
ERSONAL
I
NJURY COULD OCCUR IF THE FOLLOWING STEPS ARE NOT FOLLOWED
EXACTLY
.
Figure 2-12: Step A) One Lever Operation
Mode
A) At the Station-in-Command, move the Port
and Starboard Control Head levers to the
Ahead detent.
B) Depress and Hold the transfer button while
moving the Port or Starboard Control Head’s
lever out of the Ahead detent.
Do Not Release
the Transfer Button
until the green LED turns
ON, indicating One Lever Operation is now
active.
Depress and Hold Transfer Button
for ½ second to toggle between
High and Low Idle
10238
Control Head
levers may be
in Neutral, Ahead,
or Astern Detent