ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 36 / 272

OPERATION
Page 2-11
2-12.2.2 Servo Throttle Functions
This section along with Section 2-12.2.1 Basic Throttle
Functions, page 2-10, allows the adjustment of the Servo
Throttle:
E0
Engine Throttle Profile
-
Select whether the Throt-
tle Servo pushes or pulls to increase speed.
E2
Throttle Minimum
-
Adjusts the position of the
Throttle Servo at Idle.
E3
Throttle Maximum
-
Adjusts the position of the
Throttle Servo at Full Throttle.
E4
Throttle Maximum Astern
-
Limits the amount of
the Astern Throttle Servo movement.
Detail information on each function is found in Section 5-
6.2.2, page 5-12.
2-12.2.3 Electronic Throttle Functions
This section along with Section 2-11.9.3 Basic Throttle
Functions, page 2-9, allows the adjustment of the Elec-
tronic Throttle:
E0
Engine Throttle Profile - Selects the type of Throt-
tle Command signal.
E2
Throttle Minimum - Adjusts the Throttle Com-
mand signal at Idle.
E3
Throttle Maximum - Adjusts the Throttle Com-
mand signal at Full Throttle.
E4
Throttle Maximum Astern - Limits the amount of
the Astern Throttle Command signal.
Detail information on each function is found in Section 5-
6.2.1, page 5-10.
2-12.3 Clutch Functions
2-12.3.1 Basic Clutch Functions
The following functions are available for all types of
clutches.
C0
Clutch Pressure Interlock - Selects the Clutch
Pressure Interlock option.
C1
Clutch Interlock Delay - Determines when the
Clutch Pressure Interlock becomes active.
C2
Proportional Pause - Selects between an In-Gear,
Neutral, or Fixed Neutral delay.
C3
Proportional Pause Time - Selects the maximum
delay during a full speed reversal.
C4
Proportional Pause Ratio - Determines if the
Ahead and Astern reversal times are the
same or if Astern is one half of Ahead.