ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 78 / 272

SET UP
Page5-2
5-1.1 Processor Display LED
5-1.2 Push Buttons
5-1.2.1 Up and Down Push Buttons
Pressing the Up or Down Push Buttons once has the follow-
ing functions:
•
Stops Normal Operation Display (running Processor Part
Number) and activates the Function Menu.
• While in the Function Menu, scrolls through the Function
Codes one at a time.
• When an Error Code (Refer to Section B-1.9, page B-21) is
displayed, scrolls through the error messages one at a
time.
• When in Set Up Mode, increases (Up) or decreases (Down)
the Value one digit at a time.
5-1.2.2 Left and Right Push Buttons
Pressing and holding the Left and Right Push Buttons
simultaneously has the following functions:
• Activates Set Up Mode as indicated by the blinking Dis-
play LED. (must hold the buttons until the blinking begins)
Figure 5-3: Display LED at Normal Operation
Figure 5-4: Display LED
Designations
• The Processor’s Display LED has four 7-segment LED’s,
which light up to show either letters or numbers.
• The Display LED will have the Processor Part Number
showing in a running pattern during Normal operation
(
Figure 5-3:
)
• The first two digit Display LED’s to the left, indicate the
Function Code, which is alphanumeric.
• The second two digit Display LED’s indicate the numeric
Value that is programmed into the Processor for the
Function Code displayed to the left.
• A decimal point indicator is located on the bottom right
corner of each Display LED.
Figure 5-5: Circuit
Board Push Buttons
The Processor has four Push Buttons located on the Circuit
Board. They are identified by the words LEFT, RIGHT, UP
and DOWN silk-screened on the Shield covering the Circuit
Board.
EXAMPLE: Running Processor Part Number during Normal Operation (9210)
Starts the Processor Part Number again, one number at a time.
12309