ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 205 / 272

TROUBLESHOOTING
Page B7-1
B7 TROUBLESHOOTING STUCK TRANSFER BUTTON
The Transfer Button is a normally open, momentary
switch. The only time the switch should close is when it
is depressed to take command or when entering or
departing various other functions. In the event that the
Transfer Button became stuck in the closed position, the
following will occur:
• The Transfer Button would have to be closed for 15 sec-
onds or more.
• The throttle and clutch are not affected.
• A solid tone is heard from all remote stations, until the
button’s contact opens or transfer to another remote sta-
tion has taken place.
If a Control Head that is not in command has a stuck
transfer button, the following will happen:
• If Control Head levers are positioned at Neutral/Idle, a
solid tone is heard from all remote stations.
• If Control Head levers are positioned other than Neutral/
Idle, a three (3) second tone is heard from all remote sta-
tions.
• Error Code
33
-
42
, depending on which remote station,
will be shown on the Processor Display.
• Command can be taken at any other operational remote
station.
• After one (1) second command can be regained at the
remote station with the stuck button as long as the prob-
lem has been corrected by depressing the transfer button.
If a stuck Transfer Button is suspected, this can be veri-
fied by looking at the Station Select status (
1
or
0
) as out-
lined in Section B6-3, page B6-3.
• An Error Code
33
-
42
will be shown on the Display,
depending on which Station is experiencing the problem.