S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-773
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message
URIB-3-UFDM_MTSSEND_FAILURE Format: MTS send; to UFDM failed with
unexpected error %d
Explanation
URIB was unable to send a route update to UFDM. This means there will be a route
missing from the FIB.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
URIB-3-XCHECK_ERROR Format: ksink_event_wait 0x%08x returned error %s
Explanation
This messages are for internal debugging only.
Parameters: Memory address, Error ...
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message
URIB-3-XRI_TYPE_ERROR Format: Unknown XRI type %u
Explanation
URIB detected unknown eXtended route information while displaying a next-hop
address.
Recommended Action
No action is required.
URIB-4
Error Message
URIB-4-INVALID_PIB Format: %s %s
Explanation
A bad protocol information block was encountered in the given situation.
Parameters: Situation, Message ...
Recommended Action
No action is required.
Error Message
URIB-4-NH_RESOLV_LUKUP Format: Could not find %s/%d while processing
%s (%d) resolve buffer
Explanation
Unresolved nexthop not cleaned up properly.
Recommended Action
No action is required.
Error Message
URIB-4-RTDEL_ERROR Format: Could not find prefix %s/%d, client
\%s\sdeleterequest'
Explanation
Route delete request was received for a non-existing route.
Parameters: Prefix, Prefix Length, Client ...
Recommended Action
No action is required.
