S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-120
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
DIAGCLIENT Messages
DIAGCLIENT-2
Error Message
DIAGCLIENT-2-DIAG_BOOTUP_COMPLETE: Module <[dec]> Bootup Test
<[chars]> has reported <[chars]>
Explanation
Bootup Test completed.
Recommended Action
Nothing to be done if the test reports SUCCESS otherwise copy the error
message exactly as it appears on the console, gather the output of show tech-support, and contact
your Cisco technical support representative with the gathered information.
Error Message
DIAGCLIENT-2-EEM_ACTION_HM_SHUTDOWN: Test <[chars]> has been disabled
as a part of default EEM action
Explanation
Informational Syslog.
Recommended Action
No action is required.
Error Message
DIAGCLIENT-2-PSS_READ_FAILURE: Read from PSS failed on Module <[dec]>
Explanation
Read operation from PSS store failed.
Recommended Action
No action is required.
Error Message
DIAGCLIENT-2-PSS_WRITE_FAILURE: Write to PSS failed on Module <[dec]>
Explanation
Write operation on PSS store failed.
Recommended Action
No action is required.
DIAGCLIENT-3
Error Message
DIAGCLIENT-3-DIAG_HM_FAIL: Module <[dec]> Health Monitoring Test
<[chars]> has failed. Please use 'show diagnostic result <target>' to see test
results
Explanation
A Health Monitoring Test has reported failure.
Recommended Action
Ensure the line card is firmly in the slot, reseat if necessary, and attempt to run
the test again if the line card is not seated properly in the slot. If the line card was properly seated
in the slot, copy the error message exactly as it appears on the console, gather the output of show
tech-support, and contact your Cisco technical support representative with the gathered information.
