S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-754
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
U6RIB Messages
Error Message
U6RIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s()
Explanation
U6RIB called a PSS API which returned an error. The error reported should be
examined for the cause.
Parameters: Failed API, Error Code, Error Description, u6RIB Function ...
Recommended Action
Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message
U6RIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error
code %d
Explanation
A severe route table error was encountered. The system may run into more errors
because of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
U6RIB-3-QADD_ERROR Format: Could not add %s to the %s queue
Explanation
A severe queue error was encountered. The system may run into more errors because
of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
U6RIB-3-QDEL_ERROR Format: Could not delete %s from the %s queue
Explanation
A severe queue error was encountered. The system may run into more errors because
of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' CLI command.
Error Message
U6RIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s
(0x%08x)
Explanation
The value provided is outside of the acceptable range.
Parameters: Range, Provider of value, Value Provided ...
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
